Albutein Caution For Usage

Directions for Use: (250 mL and 500 mL for 5% solution); (50 mL and 100 mL for 20% and 25% solutions).
When an Administration Set is Used: Flip off plastic cap on top of the vial and expose rubber stopper. Cleanse exposed rubber stopper with suitable germicidal solution, being sure to remove any excess. Observe aseptic technique and prepare sterile intravenous equipment as follows: 1. Close clamp on administration set.
2. With bottle upright, squeeze drip chamber thrust piercing pin straight through stopper center. Do not twist or angle.
3. Immediately invert bottle, release drip chamber to automatically establish proper fluid level in drip chamber (half full).
4. Attach infusion set to administration set, open clamp and allow solution to expel air from tubing and needle, then close clamp.
5. Make venipuncture and adjust flow.
6. Discard all administration equipment after use. Discard any unused contents.
When an Administration Set is Not Used: Flip off plastic cap on top of the vial and expose rubber stopper. Cleanse exposed rubber stopper with suitable germicidal solution, being sure to remove any excess. Observe aseptic technique and prepare sterile intravenous equipment as follows: 1. Using aseptic technique, attach filter needle to a sterile disposable plastic syringe.
2. Insert filter needle into Albutein.
3. Aspirate Albutein from the vial into the syringe.
4. Remove and discard the filter needle from the syringe.
5. Attach desired size needle to syringe.
6. Discard all administration equipment after use. Discard any unused contents.