Flixonase Patient Counseling Information

Instructions for Use/Handling: The spray has a dust cap which protects the nozzle and keeps it clean. Remember to take this off before using the spray. A new spray (or one that has not been used for a few days), may not work first time so you will need to prepare the nasal spray following the instructions as follows.
Preparing the nasal spray: You must prepare the nasal spray: Before you use it for the first time.
If you have not used it for a few days.
If you have just cleaned it following the instructions under 'Cleaning the nasal spray'.
Preparing the nasal spray helps to make sure you always get the full dose of medicine. Follow these steps: Shake the nasal spray and remove the dust cap by gently squeezing the ribbed sides with your forefinger and thumb and pulling it straight off. Do not twist it off.
Hold the nasal spray upright and point the nozzle away from you.
Put your forefinger and middle finger on the collar either side of the nozzle and put your thumb underneath the bottle.
Keep your thumb still, and press down firmly on the collar with your fingers to release a fine spray into the air.
The nasal spray is now ready for use.
If you think the nozzle may be blocked, don't use a pin or anything sharp to clear it.
Try to clean it by following the instructions under "Cleaning the nasal spray".
Using the Spray: 1. Shake the nasal spray and remove the dust cap.
2. Blow your nose to clear your nostrils.
3. Close one nostril with your finger and carefully place the nozzle in the other nostril. Tilt your head forward a little bit and hold the nasal spray upright.
4. As you breathe in through your nose, press down firmly on the collar with your fingers.
5. Breathe out through your mouth.
6. Repeat steps 3 to 4 for your other nostril.
7. After using your spray, wipe the nozzle carefully with a clean tissue or handkerchief.
8. Replace the dust cap.
Cleaning the Spray: You must clean your nasal spray at least once a week to stop the nozzle from blocking up. Follow these steps: Remove the dust cap.
Remove the nozzle by pulling upwards on the collar.
Soak the nozzle and dust cap in warm water for a few minutes.
Then rinse under a running tap.
Shake off the excess water and let them dry in a warm place.
Put the nozzle back on the spray.